Description of Perforerbånd for Offset, center, papir - 1,8 m rulle

• Installation:
  The back pressure cylinder is cleaned of oil and grease.
  Offset plates are produced with auxiliary points for perforating band positioning.
  An impression is taken on the impression cylinder.
  A suitable piece of perforating tape is cut off.
  The protective paper for the perforating tape adhesive is removed and the perforating tape is placed on the impression cylinder in the correct position for the auxiliary points and stuck in place.
  The tape provided is applied over the perforating tape.
  
  If the perforation is too strong, apply one or more layers of tape over the perforating tape. If the perforation is too weak, apply a strip of tesafix adhesive film under the perforation tape
  
  Size guide:
  3" = Gap 0.8 mm - Length of insert 7.7 mm
  6" = Gap 0.8 mm - Length of insert 3.53 mm
  8" = Gap 0.8 mm - Length of insert 2.48 mm
  12" = Gap 0.7 mm - Length of insert 1.42 mm
  16" = Gap 0.6 mm - Length of insert 0.90 mm
• See your delivery time